F1 Rocket Hangar

Speed...Speed and Looks...Looks and Speed!

  • The Airplane Builder
  • F1 Rocket Info
    • F1 Rocket Specs
    • F1 Rocket Build Tips
  • F1 Build Log
  • About
    • Disclosure
  • Stewart 51 Hangar
  • Resources
  • Ask Mike | Contact

Right Elevator Assembly

April 29, 2015 by admin Leave a Comment

Building of the right elevator is now underway. Lots of straight forward work here so I’m not going to elaborate too much. At this point I’m just following the RV builders manual instructions.  I got as far as being able to apply primer to the elevator skin once all the stiffeners, spar and ribs were test […]

Rudder Stiffener Riveting Redux

May 31, 2014 by admin Leave a Comment

I recently received the replacement rudder skin for the one that I messed up a few weeks back, while riveting on the stiffener angles. While riveting this one, I made darn sure that the back riveting plate was under where I was riveting.  Everything was going great, until I got to the trailing edge.  I got […]

Rudder Spar Riveting

May 25, 2014 by admin 2 Comments

This evening I riveted the rudder hinge mounting brackets and reinforcing plates. One item of caution here is just to remember that you will be using longer rivets than are called for in the RV-8 plans. So make sure you check each rivet for the correct length before you start riveting. In the picture below […]

Vertical Fin Reinforcing Plates

May 24, 2014 by admin Leave a Comment

Another F1 Rocket modification to be accomplished is adding additional reinforcing plates to the vertical fin spar hinge attach points (in the top and mid locations). The additional plate at the upper fin location is made from 2024-T3, 0.063″ material and trimmed to be large enough to pick up all the rivet holes of the […]

« Previous Page
Next Page »
Profile Photo 1 Hello - My name is Mike and I'm a true believer that if you can imagine something, it's just a matter of bringing it into reality.

Categories

  • Empennage
    • Elevators
      • Left Elevator
        • Trim Tab
      • Right Elevator
    • Horizontal Stabilizer
    • Rudder
    • Vertical Fin
  • In My Travels
  • Primer
  • Tools
  • Uncategorized
  • Wings
    • Ailerons
    • F-404 Bulkhead
    • Flaps
    • Fuel Tanks
    • Leading Edge
    • Left Wing
    • Rear Wing Spar
    • Right Wing
  • Workshop

Tags

Ailerons Anti-Hang Up Guide Countersink Dimpling Doubler E-606-PP Elevator Empennage F-404 Bulkhead Flaps Fuel Sender Fuel Tank Hinge Horizontal Stabilizer HS-3101 HS-3201 Jigs Leading Edge Main Squeeze Mods Oshkosh priming rear spar Rib spacing Riveting Rudder Rudder Brace Horn Screw-ups Spar spreader bars Stiffener Tools Trap Door TrimTab Vertical Fin VS-001 VS-002 VS-803PP VS-808PP W-407B W-407C W-407D Wing Wings Workshop

Copyright © 2024 · Beautiful Pro Theme on Genesis Framework · WordPress · Log in