F1 Rocket Hangar

Speed...Speed and Looks...Looks and Speed!

  • The Airplane Builder
  • F1 Rocket Info
    • F1 Rocket Specs
    • F1 Rocket Build Tips
  • F1 Build Log
  • About
    • Disclosure
  • Stewart 51 Hangar
  • Resources
  • Ask Mike | Contact

Horizontal Stabilizer – Center hinge bearing riveting

September 24, 2017 by admin Leave a Comment

I didn’t have much time today so I just tackled a quick job by riveting the HS-411PP.  This is pretty self explanatory, so I’ll keep this entry short. As usual, all of this riveting was accomplished by using Main Squeeze hand squeezer.

Last Bit of Vertical Stabilizer Riveting

May 13, 2016 by admin Leave a Comment

Today I’m splitting my post into 2 entries. This first part is just to document the last bit of vertical stabilizer riveting. I just had to finish up with adding rivets to the root rib at the lower end of the VS. In the picture below, you’ll note that I am using the “Main Squeeze” […]

Rudder Spar Riveting

May 25, 2014 by admin 2 Comments

This evening I riveted the rudder hinge mounting brackets and reinforcing plates. One item of caution here is just to remember that you will be using longer rivets than are called for in the RV-8 plans. So make sure you check each rivet for the correct length before you start riveting. In the picture below […]

Profile Photo 1 Hello - My name is Mike and I'm a true believer that if you can imagine something, it's just a matter of bringing it into reality.

Categories

  • Empennage
    • Elevators
      • Left Elevator
        • Trim Tab
      • Right Elevator
    • Horizontal Stabilizer
    • Rudder
    • Vertical Fin
  • In My Travels
  • Tools
  • Uncategorized
  • Wings
    • Ailerons
    • F-404 Bulkhead
    • Flaps
    • Left Wing
    • Rear Wing Spar
  • Workshop

Tags

Ailerons Countersink Dimpling Doubler E-606-PP Elevator Empennage F-404 Bulkhead Flaps Horizontal Stabilizer HS-708 HS-3101 HS-3201 Layout Little Bit Main Squeeze Mods Other Rockets priming rear spar Rib spacing Riveting Rudder Rudder Brace Horn Screw-ups spacer blocks Spar spreader bars Stiffener Template Tools TrimTab Unboxing Vertical Fin VS-001 VS-002 VS-803PP VS-808PP W-407B W-407C W-407D Wayne Hadath Wing Wings Workshop

Copyright © 2023 · Beautiful Pro Theme on Genesis Framework · WordPress · Log in